![]() When the connection on the primary link is recovered, Kerio Control automatically switches back to it. Multiple Internet Links - Failover - if the primary link fails, Kerio Control switches to the secondary link automatically.Only a single-link connection is for IPv6. It is also possible to use dial-like links that can be connected persistently - typically PPPoE connections. In this case, only one Internet connection is available and it is used persistently. A Single Internet Link - the most common connection of local networks to the Internet.To move an interface to another group, drag it by mouse to the desired destination group, or select the group in the properties of the particular interface.įor networks using IPv4, it is possible to use one or more Internet connections. You can configure interfaces directly in the Interfaces section. Click Close to finish the configuration wizard.įor more information, please refer to Configuration Assistant.ĭuring the initial firewall configuration by the wizard, interfaces will be arranged into groups automatically. This classification can be changed later.(Optionally) Enable " Use DHCP for clients". Select the Internet Link connection mode:.Choose the connectivity mode: Single Internet Link, Two Internet Links with Load Balancing or Failover.Click More Actions > Configure in Wizard.In the administration interface, go to Interfaces.VLAN - If your network architecture is built on VLANs, you can add VLANs as interfaces.Ī configuration wizard is available for the setup of basic interface parameters:.You can take a port from the switch and make it a standalone interface from the port. Port in Kerio Control Box - In the Interfaces section displays the LAN switch interface.If you use a Kerio Control Virtual Appliance, you must create a new network adapter in your Hyper-V or VMware environment. If you use a Kerio Control Software Appliance, you must put a new network adapter (NIC) to the Kerio Control computer. Network adapter - Each new network adapter in the Kerio Control computer displays as an interface in the Interfaces section.Other Interfaces - interfaces that do not belong to any of the groups listed above (i.e.Guest Interfaces - interfaces that can be used for Guest LANs.IPsec and Kerio VPN interfaces - virtual network interfaces ( Kerio VPN, IPsec VPN),.Trusted/Local Interfaces - interfaces connected to local private networks protected by the firewall,.Internet Interfaces - interfaces which can be used for Internet connection,.In Kerio Control, you can define the following groups of interfaces: This article provides information on how configure Network interface settings and Internet connectivity modes: Single Link, Multiple Internet Links Failover, and Load Balancing. The default network interface routing controls traffic passing through network adapters that are connected to these networks. Kerio Control represents a gateway between two or more networks, typically between the local network and the Internet.
0 Comments
Leave a Reply. |